Chevrolet Cruze Owners Manual: Roof
The sunroof only operates when the ignition is in ON/RUN or ACC/ ACCESSORY, or when Retained Accessory Power (RAP) is active.
To open or close the sunroof, press the open or close sunroof switch (1) to the first detent position.
To express open or close the sunroof with the safety function enabled, press the open or close sunroof switch (1) to the second detent position and release. To stop the movement, press the switch again.
To automatically tilt or close the sunroof, press the tilt open or close sunroof switch (2).
If an object is in the path of the sunroof while it is closing, the anti-pinch feature will detect the object and stop the sunroof.
The sunroof glass panel cannot be opened or closed if the vehicle has an electrical failure.
The sunshade is manually operated.
Close or open the sunshade by sliding. When the sunroof is opened, the sunshade is always open.
If the sunroof has any resistance during automatic closing, it will immediately stop and reverse.
To override the safety function, press and hold the close sunroof switch. The sunroof closes without the safety function. To stop the movement, release the switch.
Dirt and debris may collect on the sunroof seal or in the track. This could cause an issue with sunroof operation, noise, or plugging within the water drainage system.
Periodically open the sunroof and remove any obstacles or loose debris. Wipe the sunroof seal and roof sealing area using a clean cloth, mild soap, and water. Do not remove grease from the sunroof.
If water is seen dripping into the water drainage system, this is normal.
Sun VisorsPull the sun visor down to block glare. Detach the sun visor from the center mount to pivot to the side window, or to extend along the rod, if available. ...
Rear Side Door Outside Handle Rod Adjustment
Removal Procedure Remove the rear door water deflector as needed. Refer to Rear Side Door Water Deflector Replacement. Use a flat-head tool to open the clip from the threaded rod connecting the lock to the outside handle. Adjust the travel of the handle by removing the threaded rod ...
Ignition Positions (Keyless Access)
The vehicle has an electronic keyless ignition with pushbutton start. Pressing the button cycles it through three modes, ACC/ACCESSORY, ON/RUN/START, and Stopping the Engine/OFF. The transmitter must be in the vehicle for the system to operate. If the pushbutton start is not working, the vehi ...
Specifications Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements are duplicated with tram bar pointers set at equal lengths.