Mazda 3 Owners Manual: Schedule 1
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.
L : Lubricate
*1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL-22 may cause serious damage to the engine and cooling system.
*2 According to state/provincial and federal regulations, failure to perform maintenance on these items will not void your emissions warranties. However, Mazda recommends that all maintenance services be performed at the recommended time or kilometer period to ensure long-term reliability.
*3 The Tire Pressure Monitoring System (TPMS) initialization must be performed so that the system operates normally (if equipped).
Schedule 2Chart symbols: I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary. R: Replace L : Lubricate C: Clean T: Tighten Remarks: *1 Use of FL-22 is recommended when r ...
Lower Panel Removal/Installation
Driver-side 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Hood release lever. d. Upper panel. e. Shift knob (MTX). f. Selector lever knob (ATX). g. Shift panel. h. Side wall. i. Cons ...
Power Window Main Switch Inspection
1. Disconnect the negative battery cable. 2. Remove the inner garnish. (driver's side). 3. Remove the front door trim. (driver's side). 4. Remove the main switch panel. (driver's side). 5. Connect the power window main switch connector. 6. Connect the negative battery cable.. ...
Liftgate Latch Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. d. Liftgate latch and lock actuator. 3. Press the latch in using a flathead screwdriver to inspect the latch lever condition. 4.