Mazda 3 Owners Manual: Wrench Indicator Light
When the ignition is switched ON, the wrench indicator light is illuminated and then turns off after a few seconds.
The wrench indicator light is illuminated when the preset maintenance period arrives. Verify the content and perform maintenance.
Refer to Maintenance Monitor on .
Low Engine Coolant Temperature Indicator Light (Blue)
The light illuminates continuously when the engine coolant temperature is low and turns off after the engine is warm.
If the low engine coolant temperature indicator light remains illuminated after the engine has been sufficiently warmed up, the temperature sensor could have a malfunction. Consult an Authorized Mazda Dealer.
Indicator LightsThese lights turn on or flash to notify the user of the system operation status or a system malfunction. Signal Indicator Lights * BSM OFF Indicator Light ...
Compression Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel ...
1. Clean the filament using isopropyl alcohol. 2. Attach tape to both sides of the filament. 3. Using a small brush or marking pen, apply silver paint. 4. After 2—3 min, carefully remove the tape without damaging the applied area. CAUTION: Do not operate the rear window defrost ...
Drive Shaft Inspection
1. Inspect the connections for any looseness. If there is any malfunction, tighten or replace the applicable part. 2. Inspect the dust boot for damage and cracks. If there is any malfunction, replace the applicable part. 3.