Nissan Sentra Service Manual: Ecm branch line circuit
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of ecm.
- Check the resistance between the ecm harness connector terminals.
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the ecm branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the ECM. Refer to EC-164, "Diagnosis Procedure".
Is the inspection result normal? YES (Present error)>>Replace the ECM. Refer to EC-485, "Removal and Installation".
YES (Past error)>>Error was detected in the ECM branch line.
NO >> Repair the power supply and the ground circuit.
Abs branch line circuitDiagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electri ...
Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can b ...
Vanity mirror lamp
Removal and installation Caution: Do not attempt to separate the vanity mirror lamp from the sun visor or damage to the components may occur. Note: The vanity mirror lamp is replaced as part of the sun visor.