Toyota Sienna Service Manual: Low Battery Positive Voltage
DTC C1241/41 Low Battery Positive Voltage
1 INSPECT ECU-IG FUSE
(a) Remove the ECU-IG fuse from the driver side J/B.
(b) Check continuity of the ECU-IG fuse.
2 CHECK BATTERY
(a) Check the positive battery voltage.
Standard voltage: 11 to 14 V
3 INSPECT SKID CONTROL ECU (IG1 TERMINAL)
(a) WHEN USING INTELLIGENT TESTER: (1) Connect the intelligent tester to the DLC3.
(2) Start the engine.
(3) Select the DATA LIST mode on the intelligent tester.
ABS / VSC:
(4) Check that the voltage condition output from the ECU displayed on the intelligent tester.
OK: "Normal" is displayed.
(b) WHEN NOT USING INTELLIGENT TESTER: (1) Disconnect the skid control ECU connector.
(2) Turn the ignition switch to the ON position.
(3) Measure the voltage according to the value(s) in the table below.
NOTICE: When replacing the brake actuator assembly, perform zero point calibration (See page BC-70).
REPLACE BRAKE ACTUATOR ASSEMBLY
4 INSPECT SKID CONTROL ECU (GND TERMINAL)
(a) Disconnect the skid control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)
Stuck in Deceleration SensorDESCRIPTION The yaw rate sensor and deceleration sensor signal is sent to the skid control ECU through the CAN communication system. When there is a malfunction in the communication, it will ...
Summary of the Blind Spot Monitor
The Blind Spot Monitor is a system that has 2 functions: The Blind Spot Monitor function Assists the driver in making the decision when changing lanes The Rear Cross Traffic Alert function Assists the driver when backing up These functions use same sensors. BSM main switch Pre ...
Engine Coolant Temperature Circuit
DESCRIPTION A thermistor is built into the Engine Coolant Temperature (ECT) sensor, of which the resistance value varies according to the ECT. The structure of the sensor and its connection to the ECM are the same as those of the Intake Air Temperature (IAT) sensor. HINT: When any ...
Driving Position Memory Switch Circuit (w/ Memory)
DESCRIPTION The seat memory switch sends signals to the outer mirror control ECU LH via the multiplex communication system to memorize a given seat position. This memory system does not use a position sensor.