Toyota Sienna Service Manual: Mute Signal Circuit between Radio and Navigation Assembly andStereo Component Amplifier
Toyota Sienna Service Manual: Mute Signal Circuit between Radio and Navigation Assembly and Stereo Component Amplifier
This circuit sends a signal to the stereo component amplifier to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier is normal, no sound, or only an extremely small sound, can be produced.
1 INSPECT STEREO COMPONENT AMPLIFIER
- Measure the voltage according to the value(s) in the table below.
2 CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - STEREO COMPONENT AMPLIFIER)
- Disconnect the radio and navigation assembly connector R15 and television display assembly connector S11.
- Measure the resistance according to the value(s) in the table below.
3 REPLACE STEREO COMPONENT AMPLIFIER
- Replace the stereo component amplifier and check if it operates normally.
OK: The navigation system operates normally
REPLACE RADIO AND NAVIGATION ASSEMBLY
AVC-LAN CircuitDESCRIPTION Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication. When a short to +B or short to ground occurs in ...
1. INSPECT SPIDER BEARING (a) Check that the spider bearing moves smoothly by turning the flange. (b) Check for the looseness around the joint by strongly moving the flange in the axial and radial directions. HINT: If necessary, replace the shaft. 2.